ADIRS Panel Pinouts

ADIRS Panel Pinouts

Panel 221VU uses LEDs for the backlight function. To drive the panel backlight you will need to supply 28 VDC and 5 VDC to the appropriate pinouts. Thank you James for the assistance. Pinouts Outputs (5 VDC) 671VC IR1 OFF 30/7 (gnd) 671VC IR1 FAULT 17/7 (gnd) 671VC ADR1 FAULT 22/7 (gnd) 671VC ADR1 OFF … Continue reading

Rudder Trim Panel Pinouts

Rudder Trim Panel Pinouts

Rudder Trim Pinouts  Parking Brake, 2124VC, A/C Back Light Trim Indicator, 2125VC, U/V (Gnd) Back Light Plate Integral Light, 2125VC, T/S (Gnd) Power 28V DC, 2124VC, V/T (Gnd) Reset Sw, 2124VC, D/K Rudder Left Sw, 2124VC, F/M Rudder Right Sw, 2124VC, H/M ARINC 429 Output, 2125VC, P, R (if using Cockpit Concept ARINC 429 boards, … Continue reading

ECAM Control Panel Pinouts

ECAM Control Panel Pinouts

Pinouts for button and LED light control connect to a low or high speed ARINC 429 transmitter board. Upper and Lower Display Unit controlled by a potentiometer. ECAM Control Panel Pinouts Canon plug B  Input Bus 1 (The DMC1 Controls illumination of the ECP Lights): G, H Input Bus 2 (The DMC2 Controls Illumination of … Continue reading

A320 GMT 4200 Electronic Clock

A320 GMT 4200 Electronic Clock

GMT 4200 Air Precision Electronic Clock The clock requires two 28 VDC supply. 5 volts required for the backlight. An interface solution with Flight Simulator X / Prepar3D / Jeehell FMGS is possible with an interface card available from Cockpit Concept. Electronic Clock Pinouts Clock Standby Supply Y (28 VDC), c (ground) Clock Normal Supply … Continue reading