Multifunction Printer Pinouts Power R (115 VAC) / N (GND)Backlight <E (5 VDC) / M (GND) AIRINC 429 ConnectionsDATA LINK T,U (connect to Cockpit Concept Printer interface board output A/B)Printer Data Out E,F (connect to input A/B) Airbourne Printer Paper P/N 9050917-0006 ReferenceAircraft Schematic Manual 31-35-01 Continue reading
The thrust pedestal refurbishment is pretty much complete. Knobs have been repainted with the assistance of Cockpit Concept. A big thank you to Mick for helping out with the flaps panel – it was in a terrible shape prior to the repaint. The Simulator Solutions converted MCDU units have been installed. Motorisation of the trim … Continue reading
11VU Throttle Quadrant 2139VC Backlight Trim E (+5 VDC) / F, G (Gnd) Backlight Gravity Gear extension A (+5 VDC) / B (Gnd) Backlight Gravity Gear extension C (+5 VDC) / D (Gnd) 2145VC Instinctive Disconnect Autothrust (L lever) A/C 2146VC Instinctive Disconnect Autotrust (R lever) A/D 8KS1 (Throttle Lever, Engine 1) Plug A Potentiometer … Continue reading
The instrument panel and pedestal backlight is controlled by the Integral Light knob found on the left side of the aircraft pedestal. To enable your panels to light up on your flight simulator, a backlight 5 volt distribution board is required. This enables you to control multiple panels with one potentiometer. There are several backlight dimming … Continue reading
Pinouts diagram remains the property of Simon Stusek. Not for commercial use, or publication without permission. pin-out_115vu Continue reading
Soarbywire 